HayesJupe's Blog

October 9, 2013

SCCM 2012 SP1 installation reboot behaviour on 3010 return code

Filed under: System Centre — hayesjupe @ 6:00 pm

Recently, we had a situation where we deployed a small client via SCCM 2012 SP1.

All tested fine and the pilot group appeared fine – but upon deploying the client widely, the customers helpdesk started getting calls about a reboot message popping up.

Sure enough, the msi has a /noreboot switch and wasn’t causing a reboot on test machines where the command was run outside of configmgr…. so what was happening?

Well – as detailed here – http://www.1e.com/blogs/2013/05/07/sccm-2012-agent-reboots-when-msiexec-uses-reallysuppress-switch/

a setting – which i think it is fair to say, a setting which isnt very clear, will cause the CM agent to initiate a reboot, even if the install command line supresses the reboot, but the return code is 3010 (soft reboot).

A little disappointing – this is the type of thing that really should be very clear in the interface…. but once finding out, its unlikely we (or you) will make the same mistake again!

Advertisements

Leave a Comment »

No comments yet.

RSS feed for comments on this post. TrackBack URI

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

Create a free website or blog at WordPress.com.

%d bloggers like this: